检查井模具生产加工 污水检查井模具的使用方法

污水检查井模具使用4mm-6mm钢板经过定尺、裁剪、弯曲成形，使用50mm-80mm长的
勒筋作为加强筋固定，污水检查井钢模具分为内模三块外模两块组合而成，方便工
人使用的时候拆卸，由于外层具有多道加强筋因此即便使用三至五年也不会发生变
形情况。
污水检查井模具的使用方法都是先在模板上涂抹脱模剂、组装模具、放置钢筋、浇
灌混凝土、振捣气泡、凝固、拆模等几个步骤。检查井钢模板配套的配件有料帽、
定位稍、连接孔、上盖、底座、凹凸槽等等，这些产品都是根据施工要求来使用的
。注浆后的检查井钢模板内部需要长时间振捣，将气泡全部排出，不然很容易让混
凝土检查井出现蜂窝麻面等问题，影响工程建设。
the sewage inspection well mold is made of 4mm-6mm steel plate, which is
scaled, cut and bent, and fixed with 50mm-80mm long rib as stiffener. the
sewage inspection well steel mold is divided into three internal molds
and two external molds, which is convenient for workers to disassemble
when using. because the outer layer has multiple stiffeners, it will not
deform even if it is used for three to five years.
the use method of
sewage inspection well mould is to apply release agent on the formwork,
assemble the mould, place reinforcement, pour concrete, vibrate bubbles,
solidify and remove the formwork. the accessories for the steel formwork
of the inspection well include material cap, positioning point,
connecting hole, upper cover, base, concave convex groove, etc. these
products are used according to the construction requirements. the steel
formwork of the inspection well after grouting needs to be vibrated for a
long time to discharge all the bubbles, otherwise it is easy to cause
problems such as honeycomb and pitted surface in the concrete inspection
well, affecting the project construction.