进口SKODA活顶针用于在机床上夹持工件

进口skoda活顶针用于在机床上夹持工件
skoda活顶针csn 24 3319
用中孔角60°或90°夹持空心工件的精密活件中心
特殊密封防止工艺液和灰尘颗粒的进入。
根据客户的要求,有广泛的特殊设计选项.
增加工件生产组合的60度和90度插入件。
这些活顶针的设计是为了在必要的情况下,用大直径的空腔夹住工件,而不能用传统类型的活顶针夹住。
the rotating part of the live center is ended with a special taper - which enables to fit clamping insert with an angle 60 ° (u1) or 90 ° (u2) as needed. in the basic version, the live centers are supplied with one set of replaceable clamping inserts corresponding to the mt size.
in the standard version, the live centers are supplied with inserts as required with a maximum ø of d according to the table. in a special design, non-disassemble live centers are also supplied - the clamping inserts cannot be removed. the special clamping inserts are also supplied as spare parts. the live centers are provided with a morse taper shank according to Čsn standard iso 296.
the live centers are supplied with lithium-based grease mogul lv2-wr. disassembly of the live centers - except for authorized service - is not recommended.
skoda活顶针csn 24 3325
头角60°或90°重工件夹持的精密活顶针
一种特殊的密封剂可以防止工艺液和灰尘颗粒的进入.
根据客户要求进行特殊设计的可能性.
选择两个精确度-正常和额外。
有可能在研磨机上使用活顶针。